• Filters
  • Sort by
  • Cobble Impregnator (NS) 5 Gallon $194.00

    Cobble Impregnator (NS) is a low-VOC, water based, clear breathable sealer for protecting natural stone surfaces. Providing a natural look appearance with no sheen, Cobble Impregnator is ideal for providing protection without changing the surface’s appearance. The breathable formula allows it to be applied in situations where film-forming sealers would not work, including and on surfaces where moisture does not readily dissipate, such as stone installed over a concrete slab.

    Each gallon of Cobble Impregnator (NS) will cover approximately 200 square feet per coat; the 5 gallon container of Cobble Impregnator (NS) will cover approximately 1,000 square feet. Coverage will depend on surface porosity, joint width and method of application. Natural Stone may require less material than other substrates.

    Over Previously Sealed: Film-forming sealers will need to be stripped prior to application. Cobble Impregnator (NS) may be applied over non film-forming sealers provided the prior application is sufficiently worn away.

    • Eco-friendly, super low VOCs
    • Protects stone, marble, concrete, and porous tile
    • Natural look (not shiny or enhanced)
    • Resists stains
    • Breathable
    • Protect concrete, marble, pavers, stone, and porous tile against stain, water, and sun damage.
    • Roof protection with low or no sheen
    • Not used to seal cracks in stucco
  • Natural Luster 5 Gallon $199.00

    Natural Luster® paver sealer from Seal ‘n Lock is a modified acrylic urethane sealer for brick pavers (with an algae and mold inhibitor) that penetrates the pavers to provide a protective barrier with superior joint stabilization (no need for polymeric sand) resulting in a natural luster. Natural Luster® paver coating is user friendly and environmentally safe.

    All Seal ‘n Lock products are made of the most environmentally-friendly products available, and offer excellent weather-ability, UV protection, and help prevent algae and mold. All of our cleaning and sealing products and specialty coatings are VOC compliant in all 50 states and exceeds all hardscape product manufacturer’s minimum standards guidelines.


    Natural Luster® is designed to be diluted with 1 part water and 1 part sealer with a 2 coat system (flood coat and top coat). Natural Luster® requires mixing and stirring (2 minutes) prior to use.


    Natural Luster® paver coating will normally dry in sunny areas within approximately 1 hour. Shaded areas, lower temperatures or high relative humidity will slow the drying process. The surface may be open to foot traffic in 24 hours and to vehicular traffic in 48 hours. To minimize tire marks, vehicles should not make sudden stops or tight turns.


    1. Immediately flush and agitate pump system after sealing with a mixture of 3 gallons water and 8 ounces of pine sol.
    2. Flush out the pump system with 5 gallons of fresh water.
    3. Pour two ounces of Pine Sol into one gallon of water, run through the pump system and leave in the pump until next application.
    4. Always run water through the pump prior to the next application.
Close My Cart
Recently Viewed Close